Sadly, there just isn’t a lot of advice out there when it comes to working with wood. You may dream of crafting a beautiful chair or table, but how do you begin. This article was written with you in mind, offering tips and tricks you just won’t find elsewhere, so read on.
Try creating your own reusable sanding blocks. Cut six 3/4″ pieces of plywood for each sandpaper grit. Make sure they are about 2.5″ x 4.75.” You can secure the sandpaper better with an adhesive. Stick a block to the cork, making sure to cut the cork flush with a utility knife. Put glue on the sandpaper and apply to the cork. Cut the sandpaper so it aligns with the cork and do not forget to label your blocks.
When sanding a piece of lumber, a lot of sawdust and debris is produced. To help remove those bits of dust and debris from your project vacuum the area. Then, remove the remaining debris using a tack cloth. Wipe both sides of the lumber to remove all traces of debris for best results.
One of the necessary tools for woodworking is the common pencil. Pencils do get lost easily, however. Buy plenty, then store them in an old instant soup container. Fill the container with sawdust and drill holes in the lid. You’ll now have plenty of pencils and the container won’t tip over easily.
Before you start any woodworking project, get all of the tools you will need for the project ready. Always remember to bring a calculator and tape measure with you when you go to purchase your wood. Make sure you have any specialty tools you will need for your project available as well.
A good method in laminating a wood project is by using tip snips to trip the laminate. These snips make it simple to trim down the laminate to a perfect size. If you can, get yourself some tin snips and then reserve them for laminate only for the best results.
Visualize your woodworking project from start to finish before taking any tool to the wood. Let your brain and imagination help you get used to what you’re about to do. In fact, when you visualize, you’ll be much less likely to make costly mistakes during the middle of a project.
If there is a joint in your work that does not fit together properly, this cannot be fixed with glue. While it may seem like the simple way to fix things, it will only work temporarily. The best thing to do would be to start over and be more careful the next time.
Stir, never shake stains and finishes before use. Over time, these settle, so mixing is necessary. Shaking, however, adds bubbles and doesn’t always mix the stain or finish thoroughly. Stirring mixes the products better by evenly mixing in any settlement that occurred during storage. Stains and finishes that are not mixed thoroughly will not apply correctly to the wood you’re staining and are at risk of looking blotchy.
With all of this advice fresh in your mind, the time is now to tackle the world of working with wood. Any project you have dreamed of creating is now within your reach. Take your time as you review each tip and start to use it as you build your first project and the results will be astounding.